Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl OLDER DECWARE GEAR SUPPORT >> CSP, CSP2, CSP2+ >> How to adjust CSP2+ https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1296757084 Message started by Steve Deckert on 02/03/11 at 18:18:04 |
Title: How to adjust CSP2+ Post by Steve Deckert on 02/03/11 at 18:18:04 Quote:
Run the volume control on the Taboo wide open. Set the volume control on the CSP2+ at the half way point. Turn both input level controls to max. Turn both output level controls to min. Turn everything on and let it warm up a few minutes. You will hear no sound. Then slowly raise the output level controls until you reach a good listening level. Your output controls are now set. Use the volume on the CSP2+ from this point on to adjust levels. - Steve Deckert |
Title: Re: How to adjust CSP2+ Post by Damien on 08/22/11 at 01:01:58 Ok I understand what you posted, thanks for that. I too, have a Taboo and a CSP2+. My source though, is usually my iMac playing Apple Lossless audio files. When the DecGear is connected via analog audio out I still have a volume control in iTunes and other audio players, along with a software Equalizer. Nothing I do with the EQ sounds as good as when I just turn the darn EQ off. Fiddle with it and I get mush, so off it goes. But what about the software Volume control? Should I place it somewhere permanently and use the preamp volume? I guess I need to know if it acts as a second preamp? Do you happen to know if the DAC Apple uses is any good? BTW I have a friend who is a music addicted person but has always had off the shelf solid state stuff, he estimated my Taboo at 150 watts per channel. LOL. Practically had an aneurysm when I told him it was 6... |
Title: Re: How to adjust CSP2+ Post by Juan Antonio on 08/27/11 at 12:47:49 Damien, the volume control by software has to be set to max. (100%/0.0 dB). |
Title: Re: How to adjust CSP2+ Post by Damien on 08/28/11 at 02:36:22 Thanks Juan, I am (obviously) new at this and appreciate all the help I can get ;) |
Title: Re: How to adjust CSP2+ Post by Juan Antonio on 08/28/11 at 10:12:44 You're welcome. |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |