Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl SPEAKER FORUMS >> NFX >> Help with NFX Duct panel https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1303758069 Message started by dwolek on 04/25/11 at 20:01:09 |
Title: Help with NFX Duct panel Post by dwolek on 04/25/11 at 20:01:09 In anticipation of my new Zen Integrated, I'm in the process of building me a set of NFX's - walnut plywood with birdseye maple caps around the driver and top - should be sweet. I purchased the plan from the website, but can't figure out the placement of the internal ducts. Specifically refering to Fig 25, it shows a 4" angled piece that I think traverses top to bottom placed against each V brace with the angle butting against the side panel. This is shown in Fig 27, but the description seems to be mis-worded. Anyway, its hard to describe at best, so I was wondering if anyone has a top down picture of duct panel. If I’m understanding this correctly, the placement of the vertical duct panel will create 4 discrete ports with sound waves travelling around the balls and out each of the side vents. Arghhh, this is so difficult to verbalize. Any help is much appreciated. Darren |
Title: Re: Help with NFX Duct panel Post by ZYGI on 04/25/11 at 23:17:40 Darren, If you look at Fig. 22 it shows the top two sit on top of the braces. The bottom one fits under the braces..... Hope this helps, ZYGI |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |