Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl SUPPORT FORUMS FOR DECWARE SPEAKER PLANS >> Deathbox Support Forum >> DBII Build Help https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1312608947 Message started by Pat32 on 08/06/11 at 06:35:47 |
Title: DBII Build Help Post by Pat32 on 08/06/11 at 06:35:47 Hello, Just want to ask; How should I round the edges on the port of the DBII box? (any pictures would be great!) Thank you |
Title: Re: DBII Build Help Post by ZYGI on 08/07/11 at 03:07:22 Pat32, Are you speaking of the DBK10 with the 1/2moon cut out? If so, round over the inside edge with a 3/8"radius bit before assembling the cabinet, then once you get the bottom on you round over the outside. Hope this helps, ZYGI |
Title: Re: DBII Build Help Post by pbLarry on 11/10/11 at 23:58:12 I'm not sure what I'm actually looking at with the Decware build. The port itself is a mere 1/2" slot at the bottom of the bell shape. I'm building one for my son and do not see any reason to round any of the sufraces. I do have good equipment and will see if there are any undesirable vorticies or disturbances from the sharp exit points but it's a sub-woofer and mathmatically a clever design that should work well. |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |