Forums - Print Page

Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl
SUPPORT FORUMS FOR DECWARE SPEAKER PLANS >> WO32 Support Forum >> WO32 8" Driver
https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1314684904

Message started by KDog on 08/30/11 at 07:15:04

Title: WO32 8" Driver
Post by KDog on 08/30/11 at 07:15:04

Hello,
Is it possible to scale the WO32 for an 8" driver? If so how have people gone about this? Does just shrinking the height work?

If it's possible I was thinking of using two 8" drivers with the following T/S parameters:
Imp: 4ohms
Re: 3.4 ohms
Fs: 28Hz
Qes: 0.31
Qms: 2.1
Qts: 0.27
Vas: 2.05 cu/ft
Xmax: 5.0mm
Sd: 220 cm^2
Spl: 90.8dB/w
Pwr: 150 watts (cont)

Sealed enclosure volumes recommended between 0.25 - 0.37 cu/ft.

Does this sound suitable?
Cheers

Title: Re: WO32 8" Driver
Post by HT-EXT on 09/06/11 at 13:24:01

I would say it can be done. I know 60 built the WO21. There is a post here somewhere with a pic of 60 and the WO21. Too cool !!!

HT-EXT

Title: Re: WO32 8" Driver
Post by phattoo on 08/10/16 at 14:17:54

Re: WO32 8" Driver
Reply #1 - 09/06/11 at 13:24:01 I would say it can be done. I know 60 built the WO21. There is a post here somewhere with a pic of 60 and the WO21. Too cool !!!

HT-EXT

Can you post a link to pic or information referenced?