Forums - Print Page

Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl
OLDER DECWARE GEAR SUPPORT >> CSP, CSP2, CSP2+ >> input level and output level controls new csp2+
https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1353373114

Message started by JD on 11/20/12 at 00:58:34

Title: input level and output level controls new csp2+
Post by JD on 11/20/12 at 00:58:34

Just received my csp2+ and finished setting it up...where do you guys have the input and output levels set at? In the notes Steve says that the pots can be set to factory calibration,would that mean that the lines on the pots should be facing 12 o'clock for the output and input levels? Right now I have my outputs at 12 but input higher...like the sound so far. An absolute beautiful piece of equipment.

On the same subject curious to those that own this and the Torii where you have the bass and treble pots set at on the Torii. I have the bass off and the treble roughly at 930am.
thanx
JD

Title: Re: input level and output level controls new csp2+
Post by Lon on 11/20/12 at 04:29:55

Whatever settings sound best to you are the correct ones to use. :) I have my inputs almost all the way up and my outputs four clicks back from all the way up. I'm primarily focused on my ZP3 right now, and that seems to be the setting for that source.

It's a very flexible preamp and it's hard not to lay with it. :)