Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl EQUIPMENT FORUMS >> SE34I.6 >> Bridging Rachael https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1382730096 Message started by Palomino on 10/25/13 at 20:41:36 |
Title: Bridging Rachael Post by Palomino on 10/25/13 at 20:41:36 I purchased another Rachael used and am thinking about bridging them and never bridged before. I found this in the Rachael manual: "You can bridge both channels into one by simply connecting the two positive speaker binding posts together. The negative posts are already connected together internally." Do I need something to split the signal to both input jacks on each amp? |
Title: Re: Bridging Rachael Post by SteveC on 10/25/13 at 21:44:43 I'm guessing you would need to Y the inputs the same when you bridge a Zen se84. I bet if you tried only one side, the volume would be weak and get louder when you plugged in the other side of the Y. |
Title: Re: Bridging Rachael Post by Lonely Raven on 10/25/13 at 22:34:41 Agreed - Rachel is an EL34 based Zen amp - so it would make sense you'd need a Y-splitter just like on the SE84. I can make you one if you decide that's the route you want to go. |
Title: Re: Bridging Rachael Post by Palomino on 10/25/13 at 23:05:33 I have a couple that I can use, but they are pretty cheap. If it shows promise, I may send you a note. |
Title: Re: Bridging Rachael Post by beowulf on 10/26/13 at 02:59:54 +1 to Lonely Raven and Steve C ~ Y Splitter, but can I get that in a Silver OCC four 9's please? ;D |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |