Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl EQUIPMENT FORUMS >> SE34I.6 >> Bridging a Rachael https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1412368542 Message started by Core32 on 10/03/14 at 21:35:42 |
Title: Bridging a Rachael Post by Core32 on 10/03/14 at 21:35:42 This statement is in the add for the new Rachael: "For the first time since it's release this wonderful amp is bridgeable into mono using the Decware Series Floating Output Bridge that eliminates the typical smear you get when you combine the channels of stereo amplifiers." What is the Series Floating Output Bridge? Is it an add on or built into the amp as designed? Thanks for your help. |
Title: Re: Bridging a Rachael Post by marky on 10/04/14 at 10:35:19 Hello core32. The floating bridge is onboard. Not sure about the tech stuff. All you do is join the +ve speaker terminals together on each amp with a piece of sheathed wire and you`re done. You speaker cable will then go into either pair of terminals as normal, one pair per amp.From the pre-amp you split the right and left with `y` connectors and send 2 rights to one Rachael, 2 lefts to the other. Or, as with the CSP pre amp with 2 outputs you send the 2 rights to one amp etc. Whether you have the Rachael without volume controls and control them by the pre-amp, or no pre-amp and loaded Rachaels are the preferences for how many signal paths you feel are needed. Lot of options. And they are allways balanced so no fiddling around. |
Title: Re: Bridging a Rachael Post by Core32 on 10/04/14 at 16:23:13 Thanks marky for your help. In the ad it just sounded like there was some option or add-on device needed by that name. Built in is obviously much better ;) So if I bought these with the standard volume control and used them with a preamp, just crank the volume knob on both amps to max and let the preamp control volume? Or is there some need to match the amps output level other than maxing the control? |
Title: Re: Bridging a Rachael Post by marky on 10/04/14 at 21:10:59 You could do that, ride the gain of the pre-amp or the amps. There`ll be a lot of settings. I have the no volumes option which I think has the rachaels on max and you access up to their max from the pre-amp. Or does it ? Maybe when I increase the pre-amp the Rachaels just increase as well. Either way I saw no need for for more pots as if it were an integrated. Even using one Rachael I controlled it from the CSP2+. |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |