Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl EQUIPMENT FORUMS >> SE34I.6 >> Speaker set-up https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1466641443 Message started by martin on 06/23/16 at 01:24:03 |
Title: Speaker set-up Post by martin on 06/23/16 at 01:24:03 I've had my amp for about 2 months now and I'm loving it. I've been wondering about a probably strange speaker set-up and want to see what you all think. I've got 2 pairs of speakers in my garage where I do most of my hanging out (the amp's here too). Both pairs (4 total) are in-wall. Right now I'm running the smaller of the pairs and it really sounds great to me. But... How would it be to attach both pairs, 4 speakers total? Each pair is 8ohms and I'm pretty sure the way to wire them is so I get a total 4ohm load. Does that seem right? I'd also like to make the speaker setup so I can "fade" between the 2 pairs. I've got left to right balance control from my computer and think I need to make a control somewhere inline with the speaker cables. Does that make sense? As long as I'm not risking hurting anything I at least want to try this. Should this be safe for my amp and speakers? IF so, I would be eternally grateful if someone could post a diagram for me. I'd offer my firstborn but that's not gonna happen at this point so that's out. ;D 8-) |
Title: Re: Speaker set-up Post by Steve Deckert on 06/23/16 at 03:12:16 First things first.... hook both pairs of speakers up to your amp and report what happens. Don't worry you can't hurt either. Steve |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |