Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl SUPPORT FORUMS FOR DECWARE SPEAKER PLANS >> WO32 Support Forum >> DVC driver wiring within/between speakers https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1515096353 Message started by bonnesone on 01/04/18 at 20:05:52 |
Title: DVC driver wiring within/between speakers Post by bonnesone on 01/04/18 at 20:05:52 WO32 w/two RSS265HO-44 (dual - 4 Ω voice-coil) Which wiring is best for each driver, which wiring gives highest subwoofer speaker fidelity? Is intra-driver, voice-coil phase alignment more important than each driver's phase alignment to the other? A dual voice coil subwoofer driver, wired parallel within, seems like best arrangement for tightest control of driver excursion - with opposing speaker's parallel coil pair firing 2nd. |
Title: Re: DVC driver wiring within/between speakers Post by deucekazoo on 01/04/18 at 22:22:43 Trying to figure out your wiring, I think on your first diagram you are paralleling the internal voice coils which would give you a 2 ohm load. But then you are paralleling them again so your amp would see a 1 ohm load. Most amps don't like that. If you would run those two drivers in series then if would be a 4 ohm load and you would be good. On the second diagram you are running each driver in series so each one would be a 8 ohm load. Then wiring them in parallel would give the amp a 4 ohm load and that would be good also. Pick which ever one is easier for you to wire, but keep it 4 ohm. I think the sonic benefits will be the same either way. |
Title: Re: DVC driver wiring within/between speakers Post by bonnesone on 01/06/18 at 00:00:02 Updated more correct drawing: Each driver's coils wired in parallel to one another and then the mirrored subs wired in series to each other. |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |