Welcome, Guest. Please
Login
or
Register
08/14/24 at 20:42:41
Most recent 50 posts
Forums
›
SPEAKER FORUMS
›
NFX
‹
Previous topic
|
Next topic
›
Pages: 1
DFR-8 cutout (Read 6509 times)
rmt
Ex Member
DFR-8 cutout
08/09/06 at 02:26:04
[quote author=Zygi link=1146081910/0#1 date=1146097859]The driver cut out (hole) is 3-19/32" R ...the driver is surface mounted.
BobZ [/quote]
On the HDT support forum this was stated by Zygi. That would make the cutout diameter 7 3/16 in diameter for the DFR-8. NFX plans show 7 inch dia. ??? I don't expect my DFR-8 drivers to get here for several days. Should I wait till they are here before I make my baffle cutouts?
Back to top
IP Logged
Steve Deckert
Administrator
If the 1st watt
sucks why continue?
Posts: 6301
Re: DFR-8 cutout
Reply #1 -
08/09/06 at 20:36:54
Yes, the DFR-8 cutout is 7-3/16 inches. The plans are done without knowing what drivers will be used. Always easier to make a hole bigger then it is to make a hole smaller. 8)
Back to top
IP Logged
Pages: 1
Forums
›
SPEAKER FORUMS
›
NFX
‹
Previous topic
|
Next topic
›
Forums
» Powered by
YaBB 2.2.2
!
YaBB
© 2000-2008. All Rights Reserved.