Hey guys, just a question for those of you that have used plate amps, where have you installed them? the best plate sub i can find to suit the drivers i have chosen is 9.5"x 9.5" and wont fit into the triangle at the begining of the horn.
I was planning of installing it into one of the sealed sub chambers, would this affect things too much?
http://www.jaycar.com.au/productView.asp?ID=AA0509&CATID=15&form=CAT&SUBCATID=44...Drivers are 150W RMS @ 8ohm (10" PA drivers from same store as amp)
AMP 600W RMS @ 4 ohms... should do the trick after i wire my drivers in parallel down to 4om