Geno
Seasoned Member
![* *](https://www.decware.com/yabbfiles/Templates/Forum/default/stargold.gif) ![* *](https://www.decware.com/yabbfiles/Templates/Forum/default/stargold.gif) ![* *](https://www.decware.com/yabbfiles/Templates/Forum/default/stargold.gif)
![](http://cdn.shortpixel.ai/client/q_lossy,ret_img,w_480,h_345/https://toptubeamplifier.com/wp-content/uploads/2018/04/glowing_vacuum_tube_52910233_original-e1612498746783.jpg)
Without music, life would be a mistake.
Posts: 2113
|
Hi Ben.
I completely understand your confusion with this. I was in the same position as you a while back trying to accomplish the same thing. I was completely lost, but forum member Palomino was able to walk me through it.
For now, take the DAC out of the equation.
First, from your SE84UFO left and right speaker POSITIVE terminals, run a single wire from each, with a RCA plug soldered onto the other end. Connect the RCA’s to the left and right inputs on the subwoofer amp (I use a Crown XLS 1002) These wires will be run in addition to the speaker wire run to the Silver 10’s. You end up with two wires on each positive SE84 speaker terminal.
Then from the subwoofer amp speaker terminals, run left and right speaker wire to the W-15’s.
The subwoofer amp has crossover and volume settings to help get the W-15’s to match up with the Silver-10’s.
I hope this isn’t too confusing. It was hard for me to grasp at first. I don’t think I left anything out.
Good luck,
Geno
|