NOTES:

Install a 15K and a 10K resistor in parallel between the two sections of the right multi-section filter cap. Connect a wire between the the 2nd section of the left multi-section filter cap and the 1st section of the right hand multi-section filter cap.

Your ground wire should connect to the bottom lug on the right hand multi-section filter cap and continue on to the input jacks. A wire lead you installed earlier on the left ms filter cap's ground lug can now be connected to the right ms filter cap's ground lug.

SOME SE84C and all SE84CS amps use a single 6.8K 1 watt resistor instead.